Minitrix 32軸再生產
版主: Rice Tang
Minitrix 32軸再生產
今天才注意到, Minitrix的32軸大物車今年底要再生產, 上次錯過的這次可以入庫了.
這是舊圖裝, 再生產是新圖裝
這是舊圖裝, 再生產是新圖裝
一邊16軸, 一邊有四個轉向架, 一個轉向架4軸. 一般裸軌都可以跑, 場景大部分都只能跑直線.
Notes about operation: This car can be used on curves with a radius of R1 194.6 mm / 7-11/16" or greater; we recommend larger curves. Signals, catenary, bridge railings, tunnel portals, etc. must be mounted far enough from curves due to the overhang of the long the "Schnabel" load arms. Your track must be mounted sturdily in place for the considerable weight of this car.
Notes about operation: This car can be used on curves with a radius of R1 194.6 mm / 7-11/16" or greater; we recommend larger curves. Signals, catenary, bridge railings, tunnel portals, etc. must be mounted far enough from curves due to the overhang of the long the "Schnabel" load arms. Your track must be mounted sturdily in place for the considerable weight of this car.
- orfina0725
- 三等資深會員
- 文章: 302
- 註冊時間: 2004-03-23 22:36
- 來自: 雲ソハアよ、約束ソ場所
- 聯繫:
R1 194.6mm的彎道耶!(小弟的場景可以過耶...)foxhsu 寫: .....(恕刪)
This car can be used on curves with a radius of R1 194.6 mm / 7-11/16" or greater; we recommend larger curves. Signals, catenary, bridge railings, tunnel portals, etc. must be mounted far enough from curves due to the overhang of the long the "Schnabel" load arms. Your track must be mounted sturdily in place for the considerable weight of this car.
不會太誇張吧
估兩個計載台的中心間距少說也有20公分
過彎時至少看到1/4弧了